TOILET PARTITIONS

Download Avonite Surfaces Toilet Partitions PDF When using Avonite Surfaces for toilet partitions, please keep in mind the following: 1/2” (12mm) Avonite Surfaces Foundations or Studio Collection Class I should be the minimum thickness used.   All hardware must have rubber grommets between the hardware and the Avonite material.   Bathroom partition hardware can be obtained from: BOMMER INDUSTRIES DECOLAM JACKNOB 803.457.3301 418.527.2544 888.231.9333 1” thick pilasters are recommended for the post going from the ground to the ceiling, obtained by utilizing the 1/2” (12mm) thick Avonite pieces.   Full channel grooves can be used when constructing the horizontal seams for vertical panels in the partitions.   Both the partition and door should use a 1”x 4” (25mmx102mm) wide build-up with a 1/2” (12mm) channel groove to receive the 1/2” (12mm) center panel. This build-up gives the panel and doors extra strength. There should be no seams on the stall door.   Wall panels should be secured to back of the wall and to pilaster with full length “U” channel. Please consult our Technical Services Department at 1.800.866.8324 for more information.